Centos 7 With Software RAID 1 and LVM For ROOT And Swap

wie Sie tun, machen, Film, Beispiel

18m 44sLänge

This tutorial guides the user through Centos 7 installation. Tells user how to change screen resolution of the installer. Creation of RAID 1 software array and installing /boot partition on the same. Creation of LVM root and swap partitions over RAID 1 software array right from the installer of Centos 7. Post OS boot information shows how it looks like. Presented to you by Hypertech Solutions.

Kommentare

how to recover raid if my one of the harddisk gets fail?
When I originally setup my system, it seems my /boot wasn't in a raid configuration. I had a disk start to go bad and tried to replace it, unfortunately it was the one with the boot record. Decided to put in 2 fresh disks and this tutorial helped me ensure both my boot and root disks were raid 1 and LVM for root and my data. Nice job, thanks.
Nice tutorial , but how about the Bios boot partition?, When I created this partition I choosed in the Device Type : Raid and I had a warning that saids "BiOS Boot must be on a device of type Standar Partition", If this partition is created as a standar partition it means that partition will be created in a single disk? how about if that disk have an issue ... I will loose this boot partition :( ?
Thank you!, finally found what I was looking for to deal with my RAID install, mute, but informative.
Sorry but this only works on a Virtual Machine. If you follow the instructions on a real machine with 2 disks you get the errors "you have not created a bootloader stage 1 target device" and " you have not created a bootable partition" when you try and write the partition table. If this error is correct then what is the /boot partition for? I have tried several solutions but I do not think it is possible to build a software RAID array using the Anaconda installer on Centos 7 on real hardware.
Amazing tutorial.. Never found such a good tutorial. Some voice commentary would be helpful. Cheers!!